alveoONE-R – assembled –
The recycling filtering kit for 3D printer
The most affordable and ready to use filtering system for 3D printers. it removes bad smells from printing and provides high protection against harmful emissions.
alveoONE-R is a free stand filterbox for you 3D printer enclosures. This kit will be printed, assembled and tested by us.
The alveoONE-R case is printed in PETG / ABS
119,99€ Inc. VAT
Made for 3D Printers
For airtight enclosure
alveoONE-R is a recycling filterbox for 3D printer which can be placed in the enclosure.
- keep a higher temperature
- Significant noise reduction
- Easy to move
- Printing time reduced
Ready to Use
Easy filter replacement
HEPA Filter P3D
- easy filter replacing
- highly reduce odours
- caught UFPs & VOCs
Protect yourself is a must, we are surrounded by too many pollution sources, avoid 3D printing source is simple with Alveo3D. Look at the filter after only 200 hours of printing.
P3D filter 2 in 1: hepa H13 and Activated Carbon
DC power supply 24V
Screw bundle M4
High Pressure Fan: 120 mm 24V
V1 Electronic Board linked with V2 controller
Sealing EPDM cord to ensure no airleaks
Easy To Install
Dimensions et Weight
HxLxW : 152*132*90mm
Assembled kit weight : 700g
Treatment VOCs (Volatile Organic Compounds): Gas
Treatment UFPs (Ultr fine particles): Nanoparticles
Ready to use. Mount and start.
DC Power supply 230v-24v
Sealing EPDM cords
Fan 24v 120*120*25mm
V1 Electronic Board 24v
Power and consumption
Voltage : 24v
Power : 10W
Operational telltale : superGreen LED
1m away from alveoONE outside enclosure : 57dB
1m away inside enclosure : 48dB
Product in Stock
Get it Now
119,99€ Inc. VAT
Markus Wolfarth (verified owner) –
I am thrilled with this filter system! The controller board in connection with the alveoONE-R filter is the best filter system I can imagine and worth every penny! I would buy it again in a heartbeat! First class, keep it up. You have developed a first class filter system.
Sigurd Decroos (verified owner) –
The fan is very loud, but this filter is very effective.
The fan is about 57 dBa, at full speed, outside the enclosure without a filter. However, it can be regulated with the controller board V2. This is not necessary to keep it at full speed all the time. To maintain a lower pressure inside your enclosure, you can increase the speed of the fan when your print is finished. This will help clean the air inside the enclosure faster and access your print safely.