alveoONE – assembled –
The filterbox for 3D printers ready to use
The most affordable and ready to use a filtering system for 3D printers. it removes bad smells from printing and provides high protection against harmful emissions. alveoONE is a wall mounted filterbox for you 3D printer enclosures.
This kit will be printed, assembled and tested by us.
You can choose the combination of materials :
PLA / ABS : enclosure below 50°C.
PETG / ABS : hot temperature inside enclosure over 50°C.
109,99€ Inc. VAT
VOCs (volatile organic compounds: toxic gas), UFPs (ultrafine particles: nanoparticles). 3D printers are registered as high harmful emitters.
Made for 3D Printers
Our HEPA filter P3D is designed for 3D printer emissions. 2 in 1 filter for the best protection against VOCs and UFPs.
Our solution is evolving to provide you more control and information to bring you efficient protection.
For non-airtight enclosure
alveoONE is a wall mounted
- keep a stable temperature
- Compact size
- Printable cutting template
- Perfect integration for all enclosure
alveoONE is a wall mounted type for 3D printer in non-airtight enclosure. Extracting air by vacuum.
Less than 170 mm high, and not even 100 mm thick.
A wall mounted type let you choose the best position for your enclosure.
In an enclosure the fan noise is reduced.
With the ring adjustment you can mount alveoONE on panel from 1 to 10mm.
Easy filter replacement
Only 30 secondes is enough to change the filter.
Extracting air allows to reduce temperature if needed.
HEPA Filter P3D
We designed our filter, especially for 3D printers. They have 3 to 6 months lifetime according to your printing time and materials you print.
- easy filter replacing
- highly reduce odors
- caught UFPs & VOCs
Protect yourself is a must, we are surrounded by too many pollution sources, avoid 3D printing source is simple with Alveo3D. Look at the filter after only 200 hours of printing.
P3D filter 2 in 1: hepa H13 and Activated Carbon
DC power supply 24V
Screw bundle M3 and M4
High Pressure Fan: 120 mm 24V
V1 Electronic Board linked with V2 controller
Sealing EPDM cord to ensure no airleaks
Easy To Install
Only 3 Steps to mount alveoONE on your enclosure. After to cut your panel according to the template just need to place the filterbox, position the ring from behind then tighten.
Dimensions et Weight
HxLxW : 172*154*90mm
Assembled kit weight: 805g
Treatment VOCs (Volatile Organic Compounds): Gas
Treatment UFPs (Ultr fine particles): Nanoparticles
Ready to use. Mount and start.
DC Power supply 230v-24v
Sealing EPDM cords
Fan 24v 120*120*25mm
V1 Electronic Board 24v
Power and consumption
Voltage : 24v
Power : 10W
Operational telltale : superGreen LED
1m away from alveoONE outside enclosure : 57dB
1m away inside enclosure : 48dB
Product in Stock
Get it Now
Don’t miss the opportunity to protect yourself and print in safe environment. We are 3D printer lovers but we dislike odors and pollutions. Choose alveoONE – KIT – and print it now.
109,99€ Inc. VAT